Soler fittings for medical gas supply systems
The planning, selection
and installation of pipework systems in medical and technical gas supply
systems in hospitals, clinics and other medical facilities not only requires a
great deal of care, but is also subject to clear specifications. As a rule, these
installations are realised with copper pipes and copper fittings. On the one
hand, copper offers very good antimicrobial properties and, on the other, can
be connected relatively quickly and safely using soldering technology.
Soldering technology in accordance with EN ISO 7396 is expressly intended as a
connection method for this special application.
Requirements for pipework for medical gases
The requirements for
piping systems for medical gases are described in EN ISO 7396-1 (Piping systems
for medical gases - Part 1: Piping systems for pressurised medical gases and
vacuum). The use of copper tubes in medical supply units is strongly recommended
in EN ISO 9170-2:2009-9 (Tapping points for piping systems for medical gases -
Part 2: Tapping points for anaesthetic gas delivery systems) and EN ISO 11197
(Medical supply units).
SANHA® offers
corresponding high-quality solder fittings made of copper (CU-DHP, CW024A) from
our own production in our factory in Belgium. With extensive experience ‘since
1964’, we produce brazing fittings for brazing that fully comply with the
requirements of EN 1254-1, -4 and 5 for medical gas supply systems and vacuum
lines in terms of purity and inner surface.
Advantages of SANHA® brazing fittings for medical gases
- Extensive range of T-pieces for the right reduction
- All our solder fittings for medical gases are manufactured in accordance with EN 1254
- The high product quality is assured by ISO 9001-2008
- Suitable for medical gases and oxygen (in accordance with EN 1057)
- Optimum corrosion resistance and hygiene requirements due to low carbon content
- All fittings are carefully degreased in specially developed washing systems
- The particularly smooth surface leads to a very good solder flow and thus contributes to a secure connection
Notes on safe and hygienic installation
In general, we recommend the use of brazing alloys CP105 / L-AG 2P, SANHA® catalogue number 4936 and CP 203 / L-CU P6, SANHA® catalogue number 4939 for brazing pure copper types.
If brazing alloys with a high silver content and/or copper alloys are joined by brazing and the use of a flux cannot be avoided. Then a flux of type FH10 in accordance with EN 1045 must be used.
In addition, no particles or flux must get into the pipes during installation. Flushing with medical compressed air (alternatively nitrogen from pressurised cylinders) is required before connecting tapping fittings.
Let's talk about it!
Are you a technical manager in a hospital, planner or engineer? Then contact us today - we will not only advise you on the selection, but also support you free of charge with the entire pipework design!
